Page 1 of 1
Factory Scrap Repair Job?
Posted: Mon Dec 15, 2014 9:52 am
by Coyote
You are looking inside the brake drum. It appears as though Suzuki (or whoever made the hubs) scrapped this one by getting the bearing bore oversize. As a repair, they installed 6 pins and re-bored the installed pins to fit the bearing. Anyway, that's how it looks to me. How about you?
Re: Factory Scrap Repair Job?
Posted: Mon Dec 15, 2014 1:12 pm
by disagt
Hi Coyote,
it seems to me, that these are no bolts, but ejector marks from manufacturing. When you press the bearing out of the bore, you will not find any bolts.
Regards
Dirk
Re: Factory Scrap Repair Job?
Posted: Mon Dec 15, 2014 8:14 pm
by Cliff
Those marks are made by staking the bearing in place.
Re: Factory Scrap Repair Job?
Posted: Tue Dec 16, 2014 6:48 am
by Suzukidave
Cliff wrote:Those marks are made by staking the bearing in place.
My thought also
Re: Factory Scrap Repair Job?
Posted: Tue Dec 16, 2014 7:34 am
by Coyote
