Suzuki 2 Strokes

Hi All,

My centre stand is missing the ‘dog-leg’ piece that sticks out to the LH side for you to push it down with. Rather than source a different stand I was going to make up replacement piece and weld it on. Can some kind T500 owner measure there’s and provide the dimensions:

L1 - Length from the stand to the first bend.
L2 - Length of the section between the bends
L3 - Length from the second bend out to the end

If you can measure to the outside of the bend i.e. include the diameter of the bar pls. Bikes a 1970, not sure there is much difference between years, but if some can provide from a similar vintage just in case

Thanks
Adrian

This looks a lot easier
http://www.ebay.com/sch/i.html?_odkw=su ... d&_sacat=0" onclick="window.open(this.href);return false;

Coyote wrote:This looks a lot easier
http://www.ebay.com/sch/i.html?_odkw=su ... d&_sacat=0" onclick="window.open(this.href);return false;" onclick="window.open(this.href);return false;

If only UK prices were as cheap as the US they are nearer 60usd here vs 10c of steel and an hours work.

L1 7cm
L2 8cm
L3 4.5cm

Cheers Parksie,

This how it turned out, look about right?




Clean up and powder coat tomorrow.

Good job for a home made effort.