Page 1 of 1
cylinder rebore UK
Posted: Sun May 24, 2015 11:57 am
by dyrberg123
Hi guys.
Anybody in here who can recommend a god rebore guy in UK or Germany for my GT750 barrels? I have new pistons my self!
Thanks in advance....
Re: cylinder rebore UK
Posted: Mon May 25, 2015 1:19 am
by yeadon_m
You could try SEP Engineering, Kegworth (I've used them) but surely the shipping will be huge vs the cost of the work?
All you need is a good local place who understands the smaller than usual clearances required by the 750 and can hold and measure (feedback to you) the clearances when done. Obviously they'll need the pistons too.
Cheers,
Mike
Re: cylinder rebore UK
Posted: Mon May 25, 2015 7:15 am
by dyrberg123
You are right Mike,
What clearance are you normally using? I seem to remember som 0,018 to 0,020 in the factory manual, do you copy that?
Re: cylinder rebore UK
Posted: Mon May 25, 2015 7:31 am
by Coyote
That's .0018 - .002. What you wrote is 18 to 20 thousandths!
Re: cylinder rebore UK
Posted: Tue May 26, 2015 10:10 pm
by dyrberg123
Your right... It migth be a bit noisy, but then again, no need for running in
But besides the missing zero it is correct right?
Re: cylinder rebore UK
Posted: Wed May 27, 2015 1:57 am
by yeadon_m
I believe so.