Swing arm swap, t250 into t500
Posted: Sat Dec 31, 2016 2:46 am
I have decided to try fitting a T250/350 swing arm into my cafe racer T500.
Has anyone else done this, are there any pitfalls I need to avoid ?
Also , does any one out there have a swing arm they would like to part with? One in Australia would make life easier, but will pay freight from elsewhere if needed.
Regards
Andrew Holley
Has anyone else done this, are there any pitfalls I need to avoid ?
Also , does any one out there have a swing arm they would like to part with? One in Australia would make life easier, but will pay freight from elsewhere if needed.
Regards
Andrew Holley